LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> ProMaster 2500 >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Ignition System (Service Information) >> Solenoid, Variable Valve Timing >> Removal >> Left Cylinder Head

Left Cylinder Head

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .
    GC0144208Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Mark the Variable Valve Timing (VVT) solenoid connectors (1) with a paint pen or equivalent so that they may be reinstalled in their original locations.

  3. Mark the intake VVT solenoid (4) and the exhaust VVT solenoid (2) with a paint pen or equivalent so that they may be installed in their original locations.
  4. Disconnect the wire harness connector (1) from the VVT solenoid (2, 4).
  5. Remove the VVT solenoid mounting bolts (3).
    GC0144209Courtesy of CHRYSLER GROUP, LLC
  6. Remove the VVT solenoid from the cylinder head cover.
    NOTE:

    The seal (1) can be reused if not damaged.

scientia non olet · About LEMON Manuals