Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
  NOTE:
  This DTC is set when the APPS values are learned in-plant but do not reach the minimum or maximum voltage range.
2. With the scan tool, erase DTCs.
3. Start the engine.
4. With the scan tool, read DTCs.
  Is the DTC active?
  
  Yes
  - Go to 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
CHECK FOR OTHER DTCS
1. Refer to the recorded DTCs.
  Are there any APP Sensor out of range and 5-volt supply DTCs active or pending?
  
  Yes
  - Perform the applicable diagnostic procedure(s). Refer to 3.6L - DIAGNOSTIC CODE INDEX .
  No
  - Go To 3
PERFORM THE ETC RELEARN FUNCTION TO DETERMINE PROPER OPERATION OF THE APP SENSOR
1. With a scan tool perform the ETC RELEARN function.
2. With the scan tool, erase DTCs.
3. Start the engine.
4. With the scan tool, read DTCs.
  Is the DTC active?
  
  Yes
  - Replace the Accelerator Pedal Position (APP) Sensor in accordance with the Service Information. After installation is complete, perform the ETC RELEARN function.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Test Complete.