Jet, Piston Oil Cooler: Installation
- Lubricate a NEW
O-ring seal (1) with engine oil and install on the piston oil cooler jet(s).NOTE:
Piston oil cooler jet for cylinders one/two shown. Piston oil cooler jets for cylinders three/four and five/six are similar.
- Install the piston oil cooler jet(s) (2) into the engine block and tighten the retaining bolt (1) to the proper specifications. Refer to ENGINE GASKET SURFACE PREPARATION
.
- Install the windage tray (1) with eight main bearing cap bolts. Tighten the bolts in the sequence shown to the proper specifications. Refer to ENGINE GASKET SURFACE PREPARATION .
- Install the oil pump. Refer to PUMP, ENGINE OIL, INSTALLATION .
- If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level. Refer to ENGINE OIL SERVICE .
- Run the engine until it reaches normal operating temperature. Check cooling system for correct fluid level.