LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> ProMaster 2500 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.6L Engine (Service Information) (2 Of 2) >> Cylinder Head >> Camshaft, Engine >> Standard Procedure >> Camshaft End Play

Camshaft End Play

  1. Remove the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, REMOVAL .
    NOTE:

    Cylinder #1 or #4 must be used when checking for Top Dead Center (TDC).

    NOTE:

    Right intake camshaft shown, other camshafts similar.

    GC0144490Courtesy of CHRYSLER GROUP, LLC
  2. Mount the Dial Indicator Set (1) to a stationary point at the front of the engine. Place the probe perpendicular against the Oil Control Valve (OCV) of the camshaft.

    (Special tool #C-3339A, Set, Dial Indicator)

  3. Move the camshaft all the way to the rear of its travel.
  4. Zero the dial indicator.
  5. Move the camshaft forward to the limit of travel and read the dial indicator. Compare the measured end play to the specification. Refer to ENGINE SPECIFICATIONS .
scientia non olet · About LEMON Manuals