Switch, EVIC Control: Removal

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the driver side airbag. Refer to AIR BAG, DRIVER, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Using a trim stick or equivalent, release the EVIC control switches (1) from the steering wheel (2).
Disconnect the wire harness connector (3) and remove the EVIC control switches (1) from the front of the steering wheel (2).