Handle, Rotating: Removal

NOTE:

It is not necessary to remove the seat from the vehicle. Rotate the seat as necessary when removing components.

Raise the seat to its highest position.

Courtesy of CHRYSLER GROUP, LLC
Using a suitable pry tool, carefully pry outward on one side of the shaft (1) then pull it off the other shaft (3). Lower the handle (4) and unclip the cable (2) from the frame.
NOTE:
It is not necessary to remove the seat cushion cover.

NOTE:
Graphic shown with seat cushion removed for clarity.
Unclip the cable from rotating mechanism, under the seat, and disconnect the cable end.
Note the routing of the cable, then remove the cable and handle as an assembly.