Actuator, Electric Park Brake: Installation

Courtesy of CHRYSLER GROUP, LLC

1. Position the Electric Park Brake (EPB) actuator and the wire harness routing bracket to the caliper.
2. Install the Electric Park Brake (EPB) actuator bolts (1) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
3. Connect the EPB actuator wire harness connector (2).
4. Remove the support and lower the vehicle.

   Courtesy of CHRYSLER GROUP, LLC

5. Connect negative battery cable (1) on negative battery post.
6. Install the battery access cover.
7. Remove the Electric Park Brake (EPB) from maintenance mode.