Pads, Brake, Front: Removal
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the wheel mounting bolts, then the tire and wheel assembly.
- Disconnect the brake pad wear sensor harness connector (1) and remove the connector from the harness bracket (2).
- Remove the caliper guide pin dust covers (3, 1).
- Remove the two brake caliper guide pin bolts (1).
- Remove the disc brake caliper (2) from the disc brake adapter bracket and hang it out of the way using wire or a bungee cord. Use care not to overextend the brake hose when doing this.
- Remove the brake pads from the caliper adapter bracket.