Fascia, Rear: Removal
- If equipped with park assist, disconnect and isolate the negative battery cable.
- If equipped with park assist, unclip the wiring connector (2) from the fascia (1) and disconnect the wiring connector.NOTE:
Left side shown in illustration, right side similar.
- Remove the left side lower fasteners (2) from the bumper cover (1).
- Repeat on the opposite side.NOTE:
Left side shown in illustration, right side similar.
- Remove the left side upper fasteners (2) from the bumper cover (1). Repeat on the opposite side.
- Remove the bumper cover from the vehicle.