Vehicle Theft Alarm
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
The hardwired circuits between modules and components related to the Vehicle Theft Alarm (VTA) system may be diagnosed using conventional diagnostic tools and procedures. Refer to the appropriate wiring information. The wiring information includes wiring diagrams, connector pinout information, and location views for the various wire harness connectors, splices, and grounds.
However, conventional diagnostic methods will not prove conclusive in diagnosing the VTA or the electronic controls and communication between other modules and devices that provide features of the VTA. The most reliable, efficient, and accurate means to diagnose the VTA or the electronic controls and communication related to VTA operation requires the use of a diagnostic scan tool. Refer to the appropriate diagnostic information.