Filler Neck

Courtesy of CHRYSLER GROUP, LLC

Lubricate a new rubber seal (2) with clean washer fluid and install it into the filler neck hole in the washer reservoir. Always use a new seal on the reservoir.
Position the filler neck and filler cap (1) into the right rear corner of the engine compartment as a unit.
Align the base of the filler neck with the filler neck opening on the top of the reservoir.
Use a back and forth twisting action to engage the base of the filler neck into the filler neck opening on the top of the reservoir.

Courtesy of CHRYSLER GROUP, LLC
Align and engage the locking wedge on the filler neck (2) with the filler neck mounting bracket. Be certain that the mounting bracket latch feature (1) snaps into the locked position over the locking wedge.
If removed, install the filter screen into the filler neck.
Fill the washer reservoir with any washer fluid drained from the filler neck during the removal procedure.