Sensor, Blind Spot: Removal

Disconnect and isolate the negative battery cable.
Remove the rear tail lamp cluster. Refer to LAMP, TAIL, REMOVAL .
Remove the side element from the rear bumper.

Courtesy of CHRYSLER GROUP, LLC
Pull the side element out in order to access and disconnect the wire harness connector (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the retainers (1).
Pry off the blind spot sensor (2a) extracting it from the mount (2b) and releasing the retainers (2c).
Remove the blind spot sensor (3).

Courtesy of CHRYSLER GROUP, LLC
If necessary, disconnect the wire harness connector (1a) from the blind spot sensor (1b).