Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read RF Hub DTCs and record on the repair order.
2. Turn the ignition off.
  NOTE:
  Do not apply the brake or the clutch in the next step.
3. Press the KIN in all positions several times.
4. Turn the ignition off and then back on.
5. With the scan tool, read RF Hub DTCs.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
EXAMINE THE KEYLESS IGNITION NODE
1. Check for anything that could cause the button to stick.
  Could you find anything that would cause a sticking condition?
  
  Yes
  - Repair as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Keyless Ignition Node (KIN) in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .