Diagnostic Test

CHECK FOR AN ACTIVE DTC 

1. Turn the ignition on.
2. With the scan tool, read RF Hub DTCs and record on the repair order.
3. Turn the ignition off and wait 30 seconds.
4. Turn the ignition on and attempt to start the engine.
5. If the engine started, wait 10 seconds then turn the ignition off.
6. Turn the ignition on.
7. With the scan tool, read RF Hub DTCs.

   Is the DTC active?

   Yes 

   • Replace the Keyless Ignition Node in accordance with the Service Information.
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

   No 

   • Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
   • If the DTC ever repeats, replace the Keyless Ignition Node in accordance with the Service Information.