LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> ProMaster 2500 >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Electronic Control Modules (Service Information) >> Module, Electronic Shift (ESM) >> Removal >> Gear Shifter Assembly Removal

Gear Shifter Assembly Removal

  1. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
  2. Remove the center instrument panel cupholder assembly. Refer to CUPHOLDER, INSTRUMENT PANEL, REMOVAL .
  3. Remove the cupholder support bracket.
    GC0203844Courtesy of CHRYSLER GROUP, LLC
    1 - Shift Cable End
    2 - Shift Cable Lock Collar
  4. Disconnect the shift cable end at the shifter.
  5. Pull the lock collar to disengage the shift cable from the shifter.
    GC0204017Courtesy of CHRYSLER GROUP, LLC
    1 - Shifter Boot
    2 - Shifter Boot Trim Ring Tabs
  6. Pull the shifter boot down.
  7. Gently pull the pry outwards on the shifter boot trim ring tabs and slide the ring away from the shifter.
    GC0203953Courtesy of CHRYSLER GROUP, LLC
    1 - Shift Knob Screw
  8. Remove the shift knob screw and the knob from the shifter.
    GC0203829Courtesy of CHRYSLER GROUP, LLC
    1 - Tow/Haul Switch Harness Connector
    2 - Shifter Bezel Retention Tabs
  9. Using a trim stick, separate shifter bezel from instrument panel.
  10. Disconnect the tow/haul switch harness connector.
    GC0203895Courtesy of CHRYSLER GROUP, LLC
    1 - Electronic Shift Module (ESM) Harness Connector
  11. Disconnect the ESM harness connector from the shifter.
    GC0203838Courtesy of CHRYSLER GROUP, LLC
    1 - Shifter Bolt Location
  12. Remove the shifter bolts.
  13. Remove the shifter through the bottom of the instrument panel.
scientia non olet · About LEMON Manuals