LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> ProMaster 2500 >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio/Video/Entertainment/Connectivity (Service Information) >> Switch, Remote Radio >> Installation

Switch, Remote Radio: Installation

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

GC0203979Courtesy of CHRYSLER GROUP, LLC
  1. Route the remote radio switch wire harness through the appropriate slot in the steering wheel and install the left and right switches (1).
    GC0204118Courtesy of CHRYSLER GROUP, LLC
  2. Connect the wire harness connectors (1).
  3. Install the Speed Control switches. Refer to SWITCH, SPEED CONTROL, INSTALLATION .
  4. Install the EVIC switches. Refer to SWITCH, EVIC CONTROL, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.