Switch, Stop Lamp: Removal

CAUTION:

Never remove or install the brake lamp switch while the brake pedal arm is disassembled from the brake booster push rod.

CAUTION:

Do not depress, lift or move the brake pedal during brake lamp switch removal to avoid switch damage. Do not depress, lift or move the brake pedal during brake lamp switch installation to avoid improper switch adjustment.

Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Disconnect the brake lamp switch wire harness connector (1).
Press the brake lamp switch (2) against the bracket while rotating the switch housing clockwise 45° to align the tabs to the keyed hole in the brake pedal support bracket.
Pull the brake lamp switch (2) straight out of the keyed hole and remove it from the vehicle.
NOTE:
If damage to the switch is present for any reason, the switch is to be replaced. If a switch is removed and the plunger length differs from a new switch, the switch should always be replaced and not reinstalled. The nominal height for a new switch (tip of the plunger to the body of the switch) is 16.9 mm (0.67 inch).