When Monitored

This diagnostic runs continuously when the following conditions are met:

• Park Assist Module (PAM) supply voltage between 9.6 - 16.6 volts.
• Vehicle system voltage between 10.0 - 16.0 volts.
• Ignition in the run position.
• PRNDL status R/D.
• System is not turned off by Park Assist disable switch.

This diagnostic runs continuously when the following conditions are met:

• Park Assist Module (PAM) supply voltage between 9.6 - 16.6 volts.
• Vehicle system voltage between 10.0 - 16.0 volts.
• Ignition in the run position.
• PRNDL status R/D.
• System is not turned off by Park Assist disable switch.