LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> ProMaster 2500 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Park Assist Module (PAM) (PTS/PAM) - DTCS B0118-95 To C1014-29 >> DTC Troubleshooting >> C100E-29-Sensor Rear Outer Right - Signal Invalid >> Diagnostic Test

Diagnostic Test

  1. CHECK FOR ANY SERVICE BULLETINS OR MODULE SOFTWARE UPDATES 
    1. Check for any applicable Service Bulletins or Flash updates related to the DTC.

      Are there any applicable Service Bulletins or Flash updates?

      Yes 

      No 

      • Go To  2
  2. READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN 
    1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
    2. For future reference, run and save a vehicle Scan Report and all related recorded data.
    3. With the scan tool, erase all DTCs.
    4. Turn the ignition off for a minimum of 10.0 seconds.
    5. Turn the ignition on.
    6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
    7. With the scan tool, read DTCs.

      Did the DTC return?

      Yes 

      • Go To  3

      No 

  3. CHECK THE PARK ASSIST SENSOR 8 FOR OBSTRUCTIONS AND THE HARNESS CONNECTOR AND TERMINALS 
    1. Turn the ignition off.
    2. Check the Park Assist Sensor 8 for the following but not limited to:
      • Free of any ice, dirt, debris or obstructions that may inhibit operation.
      • Damage to the sensor.
      • Installed properly and no damage to mounting components or O-ring.
      • The connector is completely plugged in and locked at the sensor.
      • Disconnect the sensor harness connector and check for pushed out or spread terminals, brinelling on terminals, discoloration from excessive heat, or corrosion and water intrusion.

      Were any issues found?

      Yes 

      • Repair or replace the found issues in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No