(Left Blind Spot Sensor Module (BSM) (LBSS) - Electrical Diagnostics)

• Diagnostic Code Index
• DTC Troubleshooting
  • C1000-44-Electronic Control Unit - Data Memory Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1000-45-Electronic Control Unit - Program Memory Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1000-46-Electronic Control Unit - Calibration/Parameter Memory Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1000-47-Electronic Control Unit - Watchdog/Safety MC Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1002-02-LBSS Radar Sensor Address Fault - General Signal Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1003-04-Blind Spot Sensor Problem - System Internal Failures
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1003-49-Blind Spot Sensor Problem - Internal Electronic Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1003-78-Blind Spot Sensor Problem - Alignment Or Adjustment Incorrect
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1003-97-Blind Spot Sensor Problem - Component Or System Operation Obstructed Or Blocked
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1004-16-Battery Voltage Input Circuit - Circuit Voltage Below Threshold
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1004-17-Battery Voltage Input Circuit - Circuit Voltage Above Threshold
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C100B-11-Left Blind Spot Sensor - Circuit Short To Ground
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C100B-15-Left Blind Spot Sensor - Circuit Short To Battery Or Open
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2000-64-Status_TTM.TRAILERGENERICFAILSTS - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • C2001-64-Status_CCAN5.SHIFTLEVERPOSITION - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • C2002-64-Status_BH_BCM2.TURNINDICATIONSTS - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2003-64-Status_CCAN3.VEHICLESPEEDVSOSIGFAILSTS - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2004-64-IPC_Vehicle_Setup.BSDENABLE - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2005-64-LBSS_OPERATIONALMODESTS - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2006-64-Status_CCAN5.LWSANGLE Status_CCAN5.LWSANGLEFAILSTS - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • C2007-64-Status_CCAN1.YAWRATE_BSM Status_CCAN1.YAWRATEFAILSTS_BSM - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • C2008-64-Engine1.REVERSEGEARSTS - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • C2009-64-TMA And TTM Trailer Detection - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • C2010-64-VIN Mismatch - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • U0010-88-B Can - Bus Off
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • U1700-86-Body Computer Module (BCM) - Signal Invalid
  • U1700-87-Body Control Module (BCM) - Missing Message
  • U1703-86-Instrument Panel Cluster (IPC) - Signal Invalid
  • U1703-87-Instrument Panel Cluster (IPC) - Missing Message
  • U1752-86-Right Blind Spot Sensor (RBSS) - Signal Invalid
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • U1752-87-Right Blind Spot Sensor (RBSS) - Missing Message
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • U1763-86-TTM (Trailer Tow Module)-Signal Invalid
  • U1763-87-TTM (Trailer Tow Module)-Missing Message