With Muffler
WARNING: This page is about a different variant/trim than selected.
- Install the muffler insulators (4) and ground straps (3).
- Align the muffler (1) to the catalytic convertor pipe flange. Install and tighten the flange (2) nuts to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Verify the tailpipe/resonator assembly is correctly positioned and properly aligned. The minimum clearance between components is 25mm (1 inch).
- Remove the support and lower the vehicle.
- Start the engine and inspect for exhaust leaks. Repair the exhaust leaks as necessary.