LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (8HP70 Automatic Transmission (Service Information)) >> Seal, Output Shaft >> Installation >> Output Shaft Seal

Output Shaft Seal

WARNING: This page is about a different variant/trim than selected.
CAUTION:

The seal must be installed flush with the case. Driving the seal deeper could damage the seal causing a leak.

  1. Position the new output shaft seal over the output shaft and against the transmission case.
  2. Using (special tool #9677, Installer, Seal) install the output shaft seal.
  3. Verify that the transmission is in PARK in order to prepare for the installation of the output shaft nut.
    GC0169779Courtesy of CHRYSLER GROUP, LLC
  4. Install the driveshaft flange (1) onto the output shaft and install a NEW  flange nut (2). Tighten the nut, with a 34 mm 12 point socket, to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  5. Stake (3) the nut.
  6. Install the driveshaft. Refer to SHAFT, DRIVE, REAR, INSTALLATION .
  7. Perform the CHECK OIL LEVEL procedure. Refer to STANDARD PROCEDURE - CHECK OIL LEVEL .
scientia non olet · About LEMON Manuals