LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (8HP70 Automatic Transmission (Service Information)) >> Pump, Transmission Oil >> Assembly

Pump, Transmission Oil: Assembly

WARNING: This page is about a different variant/trim than selected.
GC0154376Courtesy of CHRYSLER GROUP, LLC
  1. Install the oil pump seal (1).
  2. Install the oil pump O-ring (2).
    GC0209084Courtesy of CHRYSLER GROUP, LLC
  3. Carefully install the drive sprocket, chain and pump body (1) as an assembly into the oil pump housing.
    GC0209083Courtesy of CHRYSLER GROUP, LLC
  4. Set the pump cover (1) onto the oil pump housing (2).
    GC0154464Courtesy of CHRYSLER GROUP, LLC
  5. Install NEW  oil pump housing bolts (1 and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0154629Courtesy of CHRYSLER GROUP, LLC
  6. Install

    NEW 

    oil pump housing inner (1) and outer (2) O-rings.

    GC0154658Courtesy of CHRYSLER GROUP, LLC
  7. Install a NEW  clutch A piston seal (2) and install the clutch A piston (1).
    GC0209103Courtesy of CHRYSLER GROUP, LLC
  8. Install the plate and clutch A belleville spring (1).
    GC0209105Courtesy of CHRYSLER GROUP, LLC
  9. Position the oil pump housing assembly (4) in a suitable arbor press.
  10. Using (special tool #8285, Compressor, Spring) (1), press on the fingers of the piston belleville spring to remove tension, and install the two halves of the split retainer ring (2).
    GC0209106Courtesy of CHRYSLER GROUP, LLC
  11. Install the hub (3).
  12. Install the clutches and spacers (4).
  13. Install the snap ring (2).
  14. Install the outer ring (1) (below the clutch B piston).
    GC0209089Courtesy of CHRYSLER GROUP, LLC
  15. Position the clutch B piston alignment tab above the notch (2) and install the clutch B piston (1) on the assembly.
scientia non olet · About LEMON Manuals