Clutch, D: Assembly
WARNING: This page is about a different variant/trim than selected.
| 1. Friction Plate |
| 2. Backing Plate |
| 3. Steel Plate |
| 4. Wave Plate |
NOTE:
If clutch discs are being replaced, soak the discs in 8HP transmission fluid before reassembly.
- Install the clutch D carrier seal rings (2).
- Place the clutch D in a suitable arbor press.
- Coat the O-rings with 8HP fluid on the clutch D (2) piston (1) and install the piston (1) onto the carrier.
- Install the wave plate (1) into the carrier first.
- Install the frictions and steels (1) into the carrier (3).
- Install the backing plate (1) last onto the carrier.
- Install the proper selective snap ring (1) onto the clutch D carrier (2).
- Install the belleville spring (1).
- Place the oil baffle (2) onto the hub of the clutch D carrier (1) and align the locking tabs.
- Using the
(special tool #8901A, Pressing Tool)
(4), compress the oil baffle (2) enough the clear the locking tabs.
- Compress the oil baffle (2) enough to clear the lock tabs, and rotate the baffle (2) to the locked position.
- Release the arbor press.