Front Engine
WARNING: This page is about a different variant/trim than selected.
FRONT ENGINE
| DESCRIPTION | N. m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Supercharger Inlet Nose | Specific torque and fastener pattern required; follow installation sequence. Refer to NOSE, INLET, INSTALLATION . | Do not reuse these fasteners. If removed, a new fastener must be installed and tighten to specifications. | ||
| Timing Chain Cover Bolts | 28 | 21 | - | |
| Lifting Stud | 55 | 41 | - | |
| Vibration Damper Bolt | 200 + 150° | 148 + 150° | - | Do not reuse these fasteners. If removed, a new fastener must be installed and tighten to specifications. |
| Water Pump-to-Timing Chain Case Cover Bolts | 28 | 21 | - | |