LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (6.2L Engine (Service Information)) >> Lubrication >> Sensor, Oil Pressure >> Installation

Sensor, Oil Pressure: Installation

WARNING: This page is about a different variant/trim than selected.
GC0209523Courtesy of CHRYSLER GROUP, LLC
NOTE:

Apply Mopar® Thread Sealant with PTFE to the sensor threads before installing into the engine block.

  1. Install the oil pressure sensor (1) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0209813Courtesy of CHRYSLER GROUP, LLC
  2. Connect the oil pressure sensor wire harness connector (1).
  3. Install the generator. Refer to GENERATOR, INSTALLATION .
scientia non olet · About LEMON Manuals