Insulator, Engine Mount, Rear: Removal
WARNING: This page is about a different variant/trim than selected.
4x4 rear engine mount isolator shown, 4x2 rear engine mount isolator similar.
- Raise and support the vehicle.
- Using a suitable jack, support transmission.
- Remove the rear engine mount isolator retaining bolts (1).
- Using a suitable jack, slightly raise the transmission to relieve the load on the crossmember.
- Remove the both transmission crossmember support bracket retaining bolts (2, 3) and remove support brackets.
Right side crossmember retaining bolts shown, left side crossmember retaining bolts similar.
- Remove the transmission crossmember retaining bolts (4) and remove the crossmember.
4x4 rear engine mount isolator shown, 4x2 rear engine mount isolator similar.
- Remove the rear engine mount isolator retaining bolts (1)
- Remove the rear engine mount isolator (2).