LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (6.2L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Front >> Installation

Insulator, Engine Mount, Front: Installation

WARNING: This page is about a different variant/trim than selected.
GC0209551Courtesy of CHRYSLER GROUP, LLC
  1. If removed, position the engine mount to engine block mounting brackets, install the retaining bolts and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0209552Courtesy of CHRYSLER GROUP, LLC
  2. Position the engine mounts (2), Install the retainers (1) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. If the right side engine mount was removed. Install the generator. Refer to GENERATOR, INSTALLATION .
  4. Lower the vehicle.
    GC0170311Courtesy of CHRYSLER GROUP, LLC
  5. Lower the Engine Support Fixture (special tool #8534C, Fixture, Driveline Support) (3) until the engine mounts are seated in the engine cradle.
  6. Remove the Engine Lift Fixture (special tool #8984C, Fixture, Engine Lifting) (1), Engine Lift Adapter (special tool #8984-UPD, Adapter, Engine Lift) (2) and the Engine Support Fixture (special tool #8534C, Fixture, Driveline Support) (3).
  7. Install the Variable Valve Timing Solenoid (VVTS). Refer to SOLENOID, VARIABLE VALVE TIMING (VVTS), INSTALLATION  .
  8. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0209549Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Left side shown, right side similar.

  9. Install both left/right engine mount lower retaining bolts (1) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  10. Position both left/right engine mount heat shields (2), install the retaining nuts (3) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  11. Position the front skid plates.
  12. Install the A/C compressor.
  13. Lower the vehicle.
  14. Position the engine oil dipstick tube, install the retaining nut at the right exhaust manifold.
  15. Install the supercharger assembly. Refer to SUPERCHARGER, INSTALLATION .
  16. Connect the negative battery cable.
scientia non olet · About LEMON Manuals