LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (6.2L Engine (Service Information)) >> Engine Block >> Retainer, Crankshaft Rear Oil Seal >> Removal

Retainer, Crankshaft Rear Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:

The crankshaft rear oil seal is integral to the crankshaft rear oil seal retainer and must be replaced as an assembly.

NOTE:

The crankshaft rear oil seal retainer can not be reused after removal.

NOTE:

This procedure can be performed in vehicle.

  1. Disconnect the negative battery cable.
  2. Remove the flexplate or flywheel if equipped. Refer to FLEXPLATE, REMOVAL  .
  3. Remove the oil pan. Refer to PAN, OIL, REMOVAL  .
    Fig 1: Crankshaft Rear Seal Oil Retainer Loosening Sequence
    GC0170149Courtesy of CHRYSLER GROUP, LLC
  4. Using the sequence shown, remove the rear oil seal retainer mounting bolts.
  5. Remove and DISCARD  the rear oil seal retainer.
scientia non olet · About LEMON Manuals