Cover(S), Cylinder Head: Removal: Right

WARNING: This page is about a different variant/trim than selected.

Perform Fuel System Pressure Release Procedure. Refer to FUEL SYSTEM PRESSURE RELEASE .
Disconnect and isolate the negative battery cable.

Courtesy of CHRYSLER GROUP, LLC
Remove the engine covers (1).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the fuel supply line (1) from fuel rail (2). Refer to QUICK-CONNECT FITTINGS .

Courtesy of CHRYSLER GROUP, LLC
Remove the Positive Crankcase Ventilation (PCV) hose from the right side cylinder head cover (1).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the wire harness connectors from the camshaft position sensor, oil pressure sending unit, and oil temperature sensor.
Disconnect the bypass valve wire harness connector (3).
Disconnect the bank one (1) and throttle outlet (2) Temperature-Manifold Absolute Pressure (TMAP) sensor wire harness connectors.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the right side fuel injector wire harness connectors (1).
Disengage the wire harness from the cylinder head cover and position aside.
Remove the ignition coils and position harness aside. Refer to COIL, IGNITION, REMOVAL .

Fig 1: RH Cylinder Head Cover Loosening Sequence
Courtesy of CHRYSLER GROUP, LLC
Using the sequence shown, remove the cylinder head cover retaining bolts.

Courtesy of CHRYSLER GROUP, LLC
Remove the cylinder head cover (1).
Clean the sealing surface of the cylinder head (2).

NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.