Cover(S), Cylinder Head: Removal: Left

WARNING: This page is about a different variant/trim than selected.

Disconnect and isolate the negative battery cable.
Remove the air cleaner body and makeup air hose. Refer to BODY, AIR CLEANER, REMOVAL .
Remove the ignition coils. Refer to COIL, IGNITION, REMOVAL .
Remove the fuel injector and ignition coil wire harness from the valve cover and position aside.

Fig 1: LH Cylinder Head Cover Loosening Sequence
Courtesy of CHRYSLER GROUP, LLC
Using the sequence shown, remove the cylinder head cover retaining bolts.

Courtesy of CHRYSLER GROUP, LLC
Remove the cylinder head cover (1).
Clean the sealing surface of the cylinder head (2).

NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.