LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (5.7L Engine (Service Information) (1 Of 2)) >> Cylinder Head >> Spring(S), Valve >> Installation

Spring(S), Valve: Installation

WARNING: This page is about a different variant/trim than selected.
NOTE:

A fulcrum assembly must be rotated to the appropriate setting as marked on the tool for proper valve spring alignment.

NOTE:

The intake seal has a smaller spring seat diameter compared to the exhaust seal.

  1. Install the valve seal.
    NOTE:

    The intake spring damper has a longer free length compared to the exhaust spring damper.

  2. Install the valve spring.
    GC0209693Courtesy of CHRYSLER GROUP, LLC
  3. Using the valve spring compressor (special tool #9065C, Compressor, Valve Spring) (3), compress the valve spring and install the valve spring retainer locks.
  4. Release the air charge (1) in the cylinder.
  5. Remove the valve spring compressor (special tool #9065C, Compressor, Valve Spring) (3).
    CAUTION:

    Verify that the pushrods are fully seated into the lifters and the rocker arms. Recheck after rocker arm shaft has been torqued to specification.

  6. Install the rocker arm shaft and push rods. Refer to ROCKER ARM, VALVE, INSTALLATION  .
  7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals