LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (6.2L Emissions Control) >> Evaporative Emissions >> Solenoid, Evaporative Emissions Purge >> Removal

Solenoid, Evaporative Emissions Purge: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:

The EVAP purge solenoid attaches to a bracket near the left rear of the engine. The solenoid will not operate unless it is installed correctly.

  1. Disconnect and isolate the negative battery cable.
    GC0180950Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the EVAP purge solenoid wire harness connector (3).
  3. Disconnect the purge line (1) from the EVAP purge solenoid.
  4. Disengage the purge hose (4) from the EVAP purge solenoid.
  5. Remove the EVAP purge solenoid (2) from the bracket.