LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (8HP95 Automatic Transmission (Service Information)) >> Clutch, E >> Assembly

Clutch, E: Assembly

WARNING: This page is about a different variant/trim than selected.
GC0154469Courtesy of CHRYSLER GROUP, LLC
1. Wave Plate
2. Friction Plate
3. Backing Plate
4. Steel Plate
NOTE:

If clutch discs are being replaced, soak the discs in 8HP transmission fluid before reassembly.

  1. Install the clutch E seal (2) and O-ring (3) on the clutch E hub (1).
    GC0154602Courtesy of CHRYSLER GROUP, LLC
  2. Install the belleville (2) spring into the clutch E hub (1).
    GC0154394Courtesy of CHRYSLER GROUP, LLC
  3. Install the clutch E thrust plate (1).
    GC0154363Courtesy of CHRYSLER GROUP, LLC
  4. Install the clutch E frictions and steels (1).
    GC0154565Courtesy of CHRYSLER GROUP, LLC
  5. Install the wave washer (1) last.
    GC0154403Courtesy of CHRYSLER GROUP, LLC
  6. Install the clutch E piston (1) onto the hub.
    GC0154612Courtesy of CHRYSLER GROUP, LLC
  7. Install the clutch E piston support (1).
    GC0154596Courtesy of CHRYSLER GROUP, LLC
  8. Place clutch E (2) in a suitable arbor press.
  9. Using the (special tool #8901A, Pressing Tool) (1), compress the clutch E enough to install the snap ring (3).
GC0154432Courtesy of CHRYSLER GROUP, LLC
scientia non olet · About LEMON Manuals