Clutch, C: Disassembly

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

1. Wave Plate

2. Friction Plate

3. Backing Plate

4. Steel Plate

Courtesy of CHRYSLER GROUP, LLC

Place clutch C (2) in a suitable press.
Using the (special tool #8680A, Installer, Damper) (1), compress the clutch C (2) enough to remove the snap ring (3).
Remove the snap ring (3).

Courtesy of CHRYSLER GROUP, LLC
Remove the clutch C retainer (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the clutch C piston (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the belleville spring (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the wave plate (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the six clutch C friction and steel plates (1) from the clutch hub (2).

Courtesy of CHRYSLER GROUP, LLC
Remove the clutch C backing plate (1) from the clutch hub (2).

Courtesy of CHRYSLER GROUP, LLC
Separate the clutch C clutch shaft (3) from the clutch hub (1).
Remove two O-rings from the clutch C shaft (2).