LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (8HP95 Automatic Transmission (Service Information)) >> Cable, Manual Park Release >> Installation >> Upper - Console Mounted

Upper - Console Mounted

WARNING: This page is about a different variant/trim than selected.
GC0158395Courtesy of CHRYSLER GROUP, LLC
  1. Route the Manual Park Release (MPR) cable (2) through the center console (1).
    GC0158401Courtesy of CHRYSLER GROUP, LLC
  2. Clip the MPR lever (1) into place.
  3. Install two screws (2) holding MPR lever.
    GC0158392Courtesy of CHRYSLER GROUP, LLC
  4. Install the center console lid and tighten three screws (2).
  5. From underneath the center console, install the MPR cable into the holding clips.
    GC0158397Courtesy of CHRYSLER GROUP, LLC
  6. Install the center console duct tube and retainers (1).
  7. Install the center console rear trim bezel.
  8. Install the center console

    Refer to CONSOLE, FLOOR, INSTALLATION .

    NOTE:

    The upper and lower cables must be attached before trim is installed.

    GC0158443Courtesy of CHRYSLER GROUP, LLC
  9. Connect the upper (4) and lower (2) MPR cables to the junction (3).
    GC0158398Courtesy of CHRYSLER GROUP, LLC
  10. Close and secure the junction cover (1).
  11. Install the left center console trim panel.
    GC0158364Courtesy of CHRYSLER GROUP, LLC
  12. Install the MPR cover (2).
scientia non olet · About LEMON Manuals