Cable, Manual Park Release: Installation: Lower

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

Route the Manual Park Release (MPR) cable (2) though the access hole in the body. Seat the grommet (1) in the body.
Raise and support the vehicle
Refer to HOISTING, STANDARD PROCEDURE .

NOTE:
Be sure that the cable grommet (1) is seated in position from the under body side.

Courtesy of CHRYSLER GROUP, LLC
Install the MPR cable (2) into the bracket (3) and lock it in place.
Install the MPR cable onto the lever ball stud.
Lower the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Attach the upper (2) and lower (4) cables to the junction (3).

Courtesy of CHRYSLER GROUP, LLC
Close and secure the junction cover (1).
Install the left side center console bezel.
Install the shifter bezel
Refer to BEZEL, SHIFTER, INSTALLATION .
Verify operation of the MPR.