Cooler, Oil: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION:

If the engine encounters a catastrophic failure, the engine oil cooler and lines must be replaced or damage to the new engine or components could result.

Courtesy of CHRYSLER GROUP, LLC

Raise and support the vehicle.
Remove the belly pan retainers (1) and remove the belly pan.
Drain the cooling system. Refer to DRAINING .

Courtesy of CHRYSLER GROUP, LLC
Remove the oil filter (1) from the oil cooler (2).

Courtesy of CHRYSLER GROUP, LLC
Remove the clamps (1) from the cooling hoses at the oil cooler and remove hoses.
Using a 12 mm Allen Wrench socket (2), remove the oil cooler retaining bolt (3).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Whenever the oil cooler is serviced, the rubber O-ring seal must be replaced.
Remove and discard the oil cooler (2) rubber O-ring seal (1).