LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (6.4L Engine (Service Information)) >> Engine Block >> Retainer, Crankshaft Rear Oil Seal >> Removal

Retainer, Crankshaft Rear Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:

The crankshaft rear oil seal is integral to the crankshaft rear oil seal retainer and must be replaced as an assembly.

NOTE:

The crankshaft rear oil seal retainer can not be reused after removal.

NOTE:

This procedure can be performed in vehicle.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the transmission. Refer to REMOVAL .
    GC0209642Courtesy of CHRYSLER GROUP, LLC
  3. Remove the flexplate (1). Refer to FLEXPLATE, REMOVAL .
  4. Remove the oil pan. Refer to PAN, OIL, REMOVAL  .
    Fig 1: Crankshaft Rear Oil Seal Retainer Plate Loosening Sequence
    GC0209649Courtesy of CHRYSLER GROUP, LLC
  5. Using the sequence shown, remove the rear oil seal retainer mounting bolts.
  6. Remove and discard the rear oil seal retainer.
scientia non olet · About LEMON Manuals