LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lamps/Lighting - Interior (Service Information) >> Lamp, Dome >> Removal >> Bulb - Front

Bulb - Front

GC0209931Courtesy of CHRYSLER GROUP, LLC
NOTE:

The front dome and reading lamps are integral to the overhead console (1) in the headliner near the windshield. Both the incandescent dome lamps and the Light Emitting Diode (LED) reading lamps share the same two lenses (2) in the overhead console. Both the dome lamps and the reading lamps are turned ON and OFF by the door ajar switches or by the interior lighting thumb-wheel of the headlight switch. The front dome lamps can be turned ON independently by depressing the lamp lenses, while the front reading lamps are turned ON or OFF independently by the two reading lamp push button switches (3). The incandescent dome lamp bulbs are serviceable; however, the LED reading lamps as well as all of the switches, lamp housings, lenses and wiring are serviced only as a unit with the overhead console assembly.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the overhead console from the headliner, but do not disconnect it. Refer to CONSOLE, OVERHEAD, FRONT, REMOVAL .
    GC0209930Courtesy of CHRYSLER GROUP, LLC
  3. At the top of the over head console (1), access and rotate the bulb holder unit (2) counterclockwise about 30 degrees to unlock it from the keyed opening in the lamp housing.
  4. Pull the bulb holder and bulb straight out of the housing.