Switch, Remote Radio: Installation
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
NOTE:
With paddle shift shown, without paddle shift similar.
- Route the Electronic Vehicle Information Center (EVIC) wire harness through the slot (2) in the steering wheel.
- If equipped, connect wire harness connectors (1) for the heated steering wheel.
- Position steering wheel lower trim (1), align retaining pins and insert into steering wheel.
- Position wire harness retainer (2) over harness and install the retaining screws (1) and tighten securely.
- Position the remote radio switches near openings and route wire harness through slots and connect to EVIC harness connectors and let switches hang.
- Position EVIC switches (3) onto steering wheel, install screws (2) and tighten securely.
- Connect the EVIC switches wire harness connectors (3).
- On back side of steering wheel install screws (1) for both EVIC switches and securely tighten.
- Install the remote radio switches (2) into steering wheel.
- Install the remote radio switch retaining screws (1) and tighten securely.
- Install the remote radio switch screw cover (1) for each.
- Install the driver air bag. Refer to AIR BAG, DRIVER, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.