Lamp, Tail Stop Turn: Removal: Lamp: Inner

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Open the liftgate to access and remove the inside trim panel from the liftgate. Refer to PANEL, TRIM, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Disconnect the two liftgate wire harness connectors (2) from the bulb socket connector receptacles on the back of each side of the inner rear tail lamp unit.
If equipped, disconnect the rear camera wire harness connector.
Remove the all nuts (1) that secure the lamp housing to the liftgate.

Courtesy of CHRYSLER GROUP, LLC
Pull away the lamp from the liftgate.