LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lamps/Lighting - Exterior (Service Information) >> Lamp, Spot >> Adjustments >> Spot Lamp Head Parking Position >> Intermediate Tube Has No Flat

Intermediate Tube Has No Flat

  1. If the spot lamp intermediate tube (3) has no flat on one side, rotate the spot lamp head towards the windshield, leaving about 2.54 centimeters (1 inch) between the outermost edge of the spot lamp and the exterior vehicle components.
  2. Tighten the set screw (12) enough to maintain the spot lamp in this position during handle installation.
  3. Install the spot lamp handle assembly. Refer to LAMP, SPOT, INSTALLATION .
  4. Adjust the set screws (12 and 13) to achieve the proper tension to maintain spot lamp position while driving, but allow free movement using the handle without excessive component wear. The up-and-down swing tension of the spot lamp is controlled by set screw nearest to the A-pillar. The 360 degree rotation tension of the spot lamp us controlled by the set screw furthest from the A-pillar.
scientia non olet · About LEMON Manuals