LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Audio (Radio) - DTCS B156B-12 To U0019-88 >> DTC Troubleshooting >> B156B-12 Satellite Radio Antenna-Circuit Short To Battery >> Diagnostic Test

Diagnostic Test

  1. CHECK THE ANTENNA CONNECTION 
    1. Turn the ignition off.
    2. Disconnect the Antenna connector at the back of the Radio.
    3. Inspect the Antenna connections.

      Are the Antenna connections clean and secure?

      Yes 

      • Go To  2

      No 

      • Repair the Antenna connection as needed.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  2. CHECK THE ANTENNA AND CABLE 
    1. Connect the Radio Diagnostic Tool (special tool #9977-6-SATXM, Antenna, Satellite/Sirus XM) to the Satellite Antenna connection on the back of the Radio.
    2. Make sure one of the front doors is still open.
    3. Using the scan tool, erase the DTCs.
    4. Turn the ignition on.
    5. Turn the Radio on.
    6. Using the scan tool, read the active Radio DTCs.
      NOTE:

      While using the 9977-6-SAT test antenna the GPS reception will not be available and GPS faults may occur. The 9977-6-SAT test tool will only enable satellite radio reception to work. For GPS reception concerns use test antenna 9977-6-GPS-GLO.

      Does the scan tool display: B156B-13-SATELLITE RADIO ANTENNA-CIRCUIT OPEN

      Yes 

      • Replace the Satellite Radio in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Go To  3
  3. TEST THE SATELLITE ANTENNA CABLE 
    1. Disconnect the Satellite Antenna cable at the Satellite Antenna.
    2. Connect the appropriate Radio Diagnostic Tool (special tool #9977-6-1, Adapter) or (special tool #9977-6-3, Adapter) to the Satellite Antenna cable at the back of the Radio.
    3. Connect the appropriate Radio Diagnostic Tool (special tool #9977-6-4, Jumper) or (special tool #9977-6-2, Jumper) to the Satellite Antenna cable at the Satellite Antenna.
    4. Measure the Resistance across the terminals on the tool.

      Is the resistance below 47.5 Ohms?

      Yes 

      • Use the Radio Diagnostic Tool (special tool #9977-6, Kit, Radio Antenna Diagnostic) to locate the short circuit, repair or replace the Satellite Antenna cable as necessary.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Replace the Satellite Antenna in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .