Outer Tube Notch Orientation And Parking Position

The following steps are used to set up the spot lamp outer tube notch (2) orientation and parking position. This adjusts the position of the handle grip and the clearance between the handle grip and the vehicle interior components.

1. Loosen the outer tube set screw (12) in the head housing (14).
2. Use the key of the handle housing (7) engaged in the outer tube notch to rotate the outer tube as required to achieve the following conditions:
   • The handle grip (10) points to approximately the 9 o'clock position for the left-hand spot lamp, or the 3 o'clock position for the right-hand spot lamp with handle housing key contacting one side of the outer tube notch.
   • The handle housing can be rotated counterclockwise for left-hand lamp or clockwise for right-hand lamp away from the contacted notch side without outer tube being rotated.
   • There is sufficient space (about 2.54 centimeters or 1 inch) between the handle grip and the vehicle to allow the handle grip to be rotated.
3. Remove the handle assembly from the spot lamp.
4. Tighten the outer tube set screw to 7.3 N.m (65 in. lbs.).