Front Fog Lamps

NOTE:

The front fog lamp switch is integral to the left multi-function switch in the Steering Column Control Module (SCCM). The SCCM also includes a microcontroller, which communicates with the Body Control Module (BCM) (also known as the Common Body Controller/CBC) over the Controller Area Network (CAN) data bus. Before performing any of the following tests, determine whether the other functions of the left multi-function switch are operational. If the other left multi-function switch functions are ineffective, diagnose and repair that problem before attempting to repair the Front Fog Lamps.

CONDITION	POSSIBLE CAUSES	CORRECTION
FRONT FOG LAMP DOES NOT ILLUMINATE	1. Ineffective or missing bulb.	1. Test and replace front fog lamp bulb if required.
	2. Ineffective ground circuit.	2. Test and repair open front fog lamp ground circuit if required.
	3. Ineffective feed circuit.	3. Test and repair open front fog lamp feed circuit if required.
	4. Ineffective EMIC (CCN) inputs or outputs.	4. Use a diagnostic scan tool and the appropriate diagnostic information for further EMIC diagnosis.
	5. Ineffective BCM inputs or outputs.	5. Use a diagnostic scan tool to test the BCM inputs and outputs. Refer to the appropriate diagnostic information.
FRONT FOG LAMP DOES NOT EXTINGUISH	1. Ineffective feed circuit.	1. Test and repair shorted front fog lamp feed circuit if required.
	2. Ineffective EMIC (CCN) inputs or outputs.	2. Use a diagnostic scan tool and the appropriate diagnostic information for further EMIC diagnosis.
	3. Ineffective BCM inputs or outputs.	3. Use a diagnostic scan tool to test the BCM inputs and outputs. Refer to the appropriate diagnostic information.