Torque Specifications
TORQUE SPECIFICATION
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | NEW FASTENER* |
|---|---|---|---|---|
| Cargo hook bolts | 20** | 15 | - | |
| Front door check to body bolts | 27 | 20 | - | |
| Front door exterior handle nuts | 9 | 7 | 80 | |
| Front door hinge pivot bolts | 35 | 26 | - | |
| Front door hinge to body bolts | 35 | 26 | - | |
| Front door hinge to door bolts | 50 | 37 | - | |
| Front door rear glass guide nuts | 9 | 7 | 80 | |
| Front door regulator nuts | 10 | - | 89 | |
| Front door striker bolts | 27 | 20 | - | |
| Front fender bolts | 9 | - | 80 | |
| Front seat back bolts | 39 | 29 | - | |
| Front seat bolts | 39 | 29 | - | |
| Hood hinge to body bolts | 28 | 21 | - | |
| Hood hinge to hood bolts | 28 | 21 | - | |
| Hood latch nuts | 9 | - | 80 | |
| Instrument panel carrier bolts | 23 | 17 | - | |
| Rear door center latch bolts | 8 | - | 71 | |
| Rear door exterior handle nuts | 8 | - | 71 | |
| Rear door hinge bolts | 27 | 20 | - | |
| Rear door interior handle bolt | 9 | - | 80 | |
| Rear door lower latch bolts | 9 | - | 80 | |
| Rear door striker bolts - center | 19 | 14 | - | |
| Rear door striker bolts - upper and lower | 9 | - | 80 | |
| Rear door upper latch bolts | 9 | - | 80 | |
| Rear seat bolts | 24 | 18 | - | |
| Sliding door center hinge bolts | 25 | 18 | - | |
| Sliding door center latch bolts | 9 | - | 80 | |
| Sliding door center track fasteners | 9 | - | 80 | |
| Sliding door exterior handle nuts | 16 | 12 | - | |
| Sliding door window grate bolts | Refer to GLASS, SLIDING DOOR, REMOVAL AND INSTALLATION . | - | - | Refer to the procedure for special tightening instructions. |
| Sliding door lower buffer bolts | 12 | 9 | - | |
| Sliding door lower hinge bolts | 25 | 18 | - | |
| Sliding door lower locating pin bolts | 12 | 9 | - | |
| Sliding door lower track fasteners | 12 | 9 | - | |
| Sliding door striker bolts | 27 | 20 | - | |
| Sliding door upper hinge bolts | 12 | 9 | - | |
| Sliding door upper locating pin bolts | 12 | 9 | - | |
| *NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. | ||||
| **USE LOC-TITE 242 OR EQUIVALENT | ||||