Pod, Switch: Installation
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
- Position the switch pod (2) to the back of the switch pod trim panel (3).
- Install and securely tighten the six screws (4) for the switch pod (2).
- Connect the wire harness connector (1) to the back of the switch pod (2).
- Position the switch pod trim panel (1) and press to install the trim panel onto the instrument panel.
- Install and securely tighten the screw (3) for the switch pod trim panel.
- Install the cup-holder insert (1) into the bottom of the cup-holder well (2).
- Position the shifter bezel (1) to the instrument panel and press to install the bezel to the instrument panel.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.