Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the 2500 HD Big Horn, 2D Pickup, 6.4L Eng VIN J, 4WD, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 1.8 | B | ||
| Front,Both Sides | 1.0 | B | ||
| Rear,Both Sides | 1.0 | B | ||
| Combination Procedure: AXLE BEARING: Replace: | ||||
| Rear,One Side,w/Full Floating Axle,Inner & Outer | Includes: Repack Wheel Bearings. | 1.4 | B | |
| Combination Procedure: AXLE SEAL: Replace: | ||||
| Rear,One Side,w/Full Floating Axle,Inner & Outer,Hub Seal & O-Ring | Includes: R&I Wheel Hub Assembly. | 1.0 | B | |
| Rear,One Side,w/Full Floating Axle,Outer,O-Ring | 0.4 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | 0.2 | B | ||
| One | 0.3 | B | ||
| Combination Procedure: CALIPER: Overhaul: | ||||
| One | 0.7 | B | ||
| Combination Procedure: CALIPER: Replace: | ||||
| One | 0.3 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: OIL SEAL WEAR SLEEVE: Replace: | ||||
| Rear,Each | 0.2 | B | ||
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Both Sides,w/Full Floating Axle | 0.8 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| 4WD, Front,Hub and Bearing Assembly,One Side | 0.6 | B | ||