Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the 1500 Big Horn, 4D Pickup Crew Cab, 3.0L Eng VIN M, 4WD, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 1.8 | B | ||
| Front,Both Sides | 1.0 | B | ||
| Rear,Both Sides | 1.0 | B | ||
| Combination Procedure: AXLE BEARING: Replace: | ||||
| Rear,w/Full Floating Rear Axle,One Side | 0.8 | B | ||
| Rear,w/Semi-Floating Rear Axle,w/Standard Differential,One Side | 1.1 | B | ||
| Rear,w/Semi-Floating Rear Axle,w/Thermal Differential,One Side | 1.5 | B | ||
| Combination Procedure: AXLE SEAL: Replace: | ||||
| Rear,Axle Shaft Bearing O-Ring,w/Full Floating Rear Axle,One Side | 0.6 | B | ||
| Rear,w/Semi-Floating Rear Axle,w/Standard Differential,One Side | 0.9 | B | ||
| Rear,w/Semi-Floating Rear Axle,w/Thermal Differential,One Side | 1.3 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | 0.2 | B | ||
| One | 0.3 | B | ||
| Combination Procedure: CALIPER: Overhaul: | ||||
| One,Front | 0.7 | B | ||
| One,Rear | Includes: Activate Electric Parking Brake Service Mode. Serviced as an Assembly. | 0.5 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One | 0.3 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing. | 0.2 | B | |
| Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable: | ||||
| Maintenance Mode | Includes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: OIL SEAL WEAR SLEEVE: Replace: | ||||
| Rear,Each | 0.2 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| 4WD, Front,Hub and Bearing Assembly,One Side | DOES NOT include wheel alignment. | 0.8 | B | |